Paul B
08-11-05, 10:59 PM
When you spin broadheads for proper alignment, do you only align the ferrule to the broadhead when glueing in or do you also need to shaft & insert before glueing in?
If you buy pre-sharpened broadheads I assume that the blades & ferrule are aligned and if the arrow is cut square the insert should also be aligned.
I have read that spinning is crucial to getting good broadhead flight. If all arrows are cut square and flush inserts then you should be able to swap broadhead between shafts.
If you buy pre-sharpened broadheads I assume that the blades & ferrule are aligned and if the arrow is cut square the insert should also be aligned.
I have read that spinning is crucial to getting good broadhead flight. If all arrows are cut square and flush inserts then you should be able to swap broadhead between shafts.