Adjusting draw length on Hoyt Magnatech

[Memo]

Just wondering if anyone could tell me how to increase the draw on a 2002 Magnatech. It is a solo cam model.
Thanks,
Memo
http://img.photobucket.com/albums/v667/memo48/magantec1.jpg

[Sparra]

Gaday Memo...It looks the same as my Cybertech with a Versa cam...If it is you take out the small grub screw and then you can rotate the inner cam..when you rotate it to its furthest position in the - direction it is in the shortest draw length.Now you can move it in the + direction to the next hole available and so on with half inch longer draw each time.there should be 8 settings.Once this is done you can take out your draw stop peg and adjust it accordingly.There is a table to determine the correct position for this peg but with mine i just placed it where i was most comfortable with the let off.
If its not a versa cam i just wasted 10 minutes, but let me know your address and i can photo copy some pages out of my manual and send them to you if you get stuck..
Regards...Sparra

[Sparra]

Why thank you Jeff...And Memo...you can download the manual as well and save me copying it for you... :wink: :wink:
Regards...Sparra

[Memo]

Sparra,
do I have to have a bow press to do this?

[Sparra]

Memo...you can get almost all the adjustments without a bow press but if your draw length hole ends up between to the 2 limb halfs you may need one...
Regards...Sparra

[Memo]

Thanks.
Is this the grub screw?
http://img.photobucket.com/albums/v667/memo48/m1.jpg
Cheers.

[Sparra]

YES

[Freebie]

THIS IS COACH ,,,,,Nah Sparra ,, you know these Financial Advisor types.... gotta do everything by the book!

[Barry]

Memo,

Download the manual from www.hoyt.com just go to the technical section. They have pics and decent instructions.

[Sparra]

So whats this Baz..My instructions aren't any good????