Bowtech Grips

[johnno]

Check out these grips for your Bowtech:

http://www.archerytalk.com/vb/showthread.php?t=343271

$72 AUD to your door and more variety of timbers than shown. They are built to the same specs as the "shrewd grips". Can also include stenciling and monograming :D

[chris]

nice very nice

Chris

[PeterM]

Yeah well spotted.

[johnno]

Guys..if anyone decides to get these grips would they please be kind enough to post a thread on how they managed to remove the existing ones without scratching up the bow. My initial inspection of mine suggests they stick like sh...t to a blanket :!: :D

[aussiehunter]

just use a blowdryer for a minute,,if they are anything like a mathews,come off in a few secs..

pat :)

[PeterM]

just use a blowdryer for a minute,,if they are anything like a mathews,come off in a few secs..

pat :)

Not with mine, you will have to heat the hell (with blow drier) of it directly on the back of the grip and use a flat blade screw driver with masking tape over the end so not to damage the paint, directly behind the neck of the grip, not the sides, but it s most likely you will ruin the original grip in doing as told straight from a Tech guy at BowTech and he was right I ruined mine.

[HOOD]

The guys at Archery Mart tried to replace a grip of a target bow and replace it with the wooden grip as thats what the customer wanted. They practicly destroyed the original grip just to get it off and that was after they tried everything to get it off in one piece.

So good luck to you I say.

[aussiehunter]

well guys i made the big mistakke thinking it would be simple like a mathews...sorry....i should have known better...im bad.... :D


pat :)

[johnno]

Yes..now go stand in the corner :D