Fletching Jig

[Sparra]

Gaday fella's...I have a BPE fletching jig that is set for 3 fletches...how do i change it to a 4 fletch jig...ie..I took the end off and there are 2 ball bearings with springs under them and 3 and 4 hole positions...so what do i do to change it????

[Kimall]

Mate it sounds like the ones I sell with the two screws in it.At the moment you should have one little screw in and one out try to swap this by screwing one in and the other out.I am only quessing mabey someone else here has one of these.
Cheers KIM

[Sparra]

Thanks Kim...Worked a treat.....
Regards...Sparra

[Howling Dog]

Also all I do is
Put the arrow in jig dont put on any cock feather, just the two hen feathers
turn the arrow back to the cock feather setting and take the arrow out & turn 180 degrees put back in and put on two hen feathers again (four fletches) works for me. Hope this helps