Ferr-L-Tite with carbon

[tw.]

Who here has used/uses Ferr-L-Tite (hot melt glue) with their carbon arrows. I'm aware it's not good to use heat with carbon but I was considering using it while i'm experimenting with lengths of some new arrows.

Opinions?

[Wellsy]

I've been using standard hotmelt lately, it works fine. Just remember to clean the inside of the shaft well.(a wire .22 bore brush does a good job)

Wellsy

[Wareagle]

The only trouble I found with hot melt on carbons, with a fast bow, the friction heats the heads up, and some times when the arrow is pulled out of a target, the head stay behind.